嘉兴市力矩电机厂家 力矩电机700图片

新乡市力矩电机生产基地-河南恒通电机力矩电动机全、高清图片。为您机械设备配套佳选。该力矩电机软特性恒定。工作状态发热退磁低。电机经久耐用，绝缘等级高于同行业。力矩安装前的准备

Third, pre-installation preparation

1.力矩电动机使用前应该检查电动机外表是否完善无损伤，有无受潮的现象。

1. The motor should be checked before using， there has to be no damage on the motor outside, and the motor can not be damped.

2.检查电动机的铭牌数据是否符合要求。

2. Check the motor nameplate data to meet the requirements.

3.仔细检查电动机在运输过程中有无变形或者损坏，紧固件有无松动或者脱落，试着用手拨动转轴，看电动机是否能灵活运转。

电动机的安装

3. Carefully check motor during transport without deformation or damage, fasteners loose or fall off, try to toggle the shaft by hand to see if the motor can operate flexibly.

4．力矩电动机应该按照其结构形式正确安装，电动机的轴伸直径出厂前已精磨至标准公差尺寸，因此要求用户所配套的皮带轮或者其他配套零件的内径尺寸一定要按照国家标准推荐的优先配合公差进行磨削或者铰削加工。安装时，用手推入或用榔头轻敲至轴伸台即可，严禁用锤猛击，否则将损坏电动机的零件，造成电动机不能正常工作。

4.You must assemble the electric motor according to the instruction types. The shaft’s diameter of the motor 

  must be grinded according to the standard size of allowable drror. So the customers will grind or cut processing 

  according to the national standard difference with complete leather belts or else parts. When you assemble 

  it, you may push the shaft lightly not use the hammer to hit it or you will demage the parts.  

5．为确保设备和人身安全，在电动机通电前，请务必把接地导线连接到电动机的接地螺钉上，并正确接地。接地导线应采用铜导线，其截面积随电动机功率的增加而加大。小功率电动机接地线的截面积应不小于1平方毫米。

5.In order to ensure the person’s safe, you must connect the earth conductor to the landing screw. The landing 

  wire should be copper. Its cross area is being increased as the electric motor’s power is adding. The across 

  area of little power motors should be not less than 1 square mm.

6．力矩电动机的安装应保证良好的通风冷却条件，不可用于热晒雨淋的场所。

6.Install the motor should ensure good ventilation and cooling conditions, it can not be used for places with 

  sun exposure or in rain.